【實用交通運輸app】EconTool ELM327 for Nissan|最夯免費app

Currently, the program is able to work with a gasoline Nissans engines via Nissan Consult protocol (Nissan Custom, Nissan JDM) - it is not OBDII. If you have an engine with OBDII protocol, you need to use other programs. The program works via BlueTooth keychains chip ELM327. The interface should be intuitive, and later will be laid out detailed video instructions for use.

The program works in three modes:

1 on-board computer.

2 ELM327 terminal.

3 Read/reset the computer errors.

In the on-board computer displays the following options (you can choose them by a long tap on a sensor):

Onboard voltage

Update values time

Engine RPM

Speed

Coolant temperature

Mass air flow

Fuel injection time

Ignition timing

Short-term fuel trim

Long-term fuel trim

Idle Air Control position

Throttle voltage sensor

Throttle position sensor

Mass air flow voltage

Instant hour fuel consumption

Instantaneous fuel consumption in Km/H

Instantaneous fuel consumption in L/100Km

Last trip: distance

Last trip: time

Last trip: time in motion

Last trip: spent fuel

Last trip: average speed

Last trip: average speed in motion

Last trip: average fuel consumption

Trip A: distance

Trip A: time

Trip A: time in motion

Trip A: spent fuel

Trip A: average speed

Trip A: average speed in motion

Trip A: average fuel consumption

Trip B: distance

Trip B: time

Trip B: time in motion

Trip B: spent fuel

Trip B: average speed

Trip B: average speed in motion

Trip B: average fuel consumption

Fuel consumption can be measured in two ways:

1) According to the MAF sensor with the ability to allow fuel trims.

2) According to the fuel injection timing. In this case, the primary performance calculations made ​​by MAF at idle RPM,

and then comes the calculation based on the time of injection and the engine speed (ie, at the time of setting MAF

should be OK).

To fine-tune your reading rate there is the correction factor, witch can be calculated as the ratio of the amount

actually spent fuel to the amount of spent fuel that shows the program.

Cars in which the program is 100% working:

Wingroad Y11 (QGxx)

AD (QGxx)

Almera (QGxx)

Liberty (QRxx)

Murano (VQxx)

X-Trail (QRxx)

Sunny (QGxx)

Maxima (VQxx)

On other machines may not be efficient, but possible.

免費玩EconTool ELM327 for Nissan APP玩免費

免費玩EconTool ELM327 for Nissan App

EconTool ELM327 for Nissan APP LOGO

EconTool ELM327 for Nissan APP QRCode