【實用工具app】RPI Automation|最夯免費app-綠色工廠好玩App

Use this app to control Raspberry Pi GPIO outputs, and view the status of 1 input. You must first have a Raspberry Pi with Webiopi installed and setup. Each button can be set to operate a different IP address, port number, GPIO pin, as well as use any button as a momentary push button (low then high, or high then low) for operating actuators for door locks, or garage doors. You can also setup the button to go high and stay high, or low and stay low for turning lights on and off as well as set the duration so you could say turn a light on for 5 minutes then turn it off. There are up to 12 buttons available, and only show up when enabled. Use the input connected to a switch to detect a door open condition or what ever you like! (No authentication, must # out password in config file for webiopi etc/webiopi/config)