【實用運動app】Traction Monitor (Cornering)|最夯免費app-綠色工廠好玩App

Fixing on you motorcycle or car, this monitor shows real time traction G force + lean angle using the built in sensors. In case, gyroscope sensor is no available on your device, (normally mounted on only higher grade model), the monitor show only side G force.

During acceleration, braking or cornering, measures and indicate the side G force. When detects an exceed force, more than the preset value, shows you alarm changing the screen color from green to red.

In case your device able to show lean angle, convert the force as a tire grip force (traction) considering centrifugal force.

< Instruction >

- Fix the device using a support. (only available for vertical direction.)

- You can adjust the angle, turning the device forward or backward direction. But frame top line must be horizontal (parallel with the wheel shaft).

- To start the monitor, keep the motorcycle on upright position (in case of motorcycle). Then, press [Calibrate] button to initialize sensors.

< Settings >

- Depending on the response of you device and the load condition, you can adjust the sensor sensibility form the "Settings" menu -> "Alarm/Sensor Setting".

- In case you use in cars, if lean angle is displayed, switch [OFF] "Indicate Lean Angle" from the same setting menu.

- Selecting "Off During Upright Acceleration", red alarm will be off in this condition. (only usable with Lean angle indicate.)

- To keep the red alarm during 5 sec, select "Keep 5 sec".

- Bumps on the load may affect the monitoring value, as the monitor use accelerometer and gyroscope sensors.

- The device should be used same as general Navigator or GPS. Don't attempt to change settings while driving . Also, don't stare at the screen while driving.